Double leaf doors

Select the leaf profile, the opening type, the glass thickness and all other parameter from the dialog box.

In case the leaves should be of different size, please deactivate the check box "Overlap centre". After leaving the dialog box, you are asked to define a reference point via "ref point <SCHN"> for entering the "relative X value". Enter the value is without @ and only positive or negative.

The following message appears subsequently:

RETURN for end of filling

First corner (bottom left)

or select point in closed contour

First make the system selection. Then select the colour. Then select the desired variant. You can see the meaning of the variant in the Info field.

The door hinge layout is based on the values specified. Three door hinges are shown in the picture. The division takes the first three values for top, centre and bottom. The 2nd value from the top is only used for a fourth hinge. If the door hinges are only attached from the top and bottom, the value for the centre can be deleted.