Sealing / Sealing with backing cord

Variant 1:

Command: "Sealing" and "Foamed tape with sealing"

Generates a sealing with or without backing cord by means of up to 4 points.

The run of the hollowing (P1 and P2) is user-defined. In case you only define a third point (P3), the sealing tape is set in a right angle (orthogonal) to the connection of P1 and P2. In case you define a fourth point you create an angular sealing.

Sealing and sealing tape are drawn separately. So it is possible to delete an element on demand.

Example:

Command: sealing

Outer sealing from point: (P1)

to point: (P2)

Backing cord to point:(P3)

Hatch style only for your information. The values should be altered in the dialog box.

Factor <0.8>

Reference / Angle of rotation: enter any value

Variant 2:

Command: "Foamed tape with sealing rectangular"

Creates a sealing with or without backing cord by means of 2 points. Define the direction with the left mouse button. The depth is changeable.

Command: First point

Point2 or for entering width x height: Second point

point for direction / depth or for OK: left mouse button for change sides, T for altering the depth, right mouse button or to draw the element

Contour layer, hatching layer, hatching pattern and spacing can  be changedin the dialogue box SYSCAD-Variable / Attachment-Details / Sealing or SYSCAD-Variable / Attachment-Details / Gasket cord