How to draw a single-leaved door with special t-bars?

- load System FORSTER

- Menu FORSTER -> fuego light EI30/EI60-> Gener. Sections

- draw the elevation with the command FRAME. At the right bottom point click the right mouse button. Choose Open+Aux. for a open frame contour with a subsidiary line.

- insert the door with the command FILLING.

- choose the command SPECIAL T-BAR START EDIT MODE and select the door.

- draw the t/m-profiles with the command T/M-PROFILE. Attention! You should see the complete door for this command.

- change corner connections and trim some profiles like in normal profile mode.

- leave the special t-bar mode with SPECIAL T-BAR  CLOSE EDIT MODE.

- build special panels with the panel generator. If you save those panels , you could use them in the command FILLING or CHANGE GLASSTHICKNESS.

- generate sections

- generate glasslists