Cut List Order

Toolbar: SYSCAD Generating sections -> SYSFLY List ->

Ribbon: SYSCAD Gener. Sections -> Cut List ->

The program CUT LIST ORDER is used to generate the following lists from SYSCAD® drawings:

•cut lists

•glass lists

•gaskets lists

•saw lists

•waste optimization

The lists can be generated in Microsoft Excel Version 8.0, 9.0 or 10 (e.g. from Office 97, 2000 and XP).

•Orders with up to 200 positions can be generated.

•The positions must be drawn with the application SYSCAD® (from version 12.11 or 13.01)

•The individual positions can be located at different drawings.

Restriction:

The calculation of the pressure plate / face cap profiles depends on the mullion / transom profiles.

Command: ZSL starts the cut list program.

You will find all commands and possibilities of the program CUT LIST ORDER in this dialog box.

The order information settings are only effective if they were set before the order was created. To make changes to an order that has already been created, double-click on the text line ORDER INFO.

The order processing dialogue box then shows the settings from the order information below the ORDER INFO line.

Excel is a registered trademark of the company Microsoft